Sliding driveway gates
Wrought iron
Wood & steel frame
Farm & ranch
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterDriveway Gate in Whitney, NV
A driveway gate in Whitney is the barrier that closes off your property from the street. Most homes here have a driveway wide enough for a two-car swing or a single sliding panel, and the gate either rolls on a track or swings on hinges driven by a motor. If you’re adding one or fixing one, we handle both: new driveway gate installation, motor replacement, hinge and post repair, and the access control that makes it open when you want it to. Call Vance Gate Repair Whitney at (844) 797-4861 and a live person answers, day or night.
We’re a gate specialist, not a general handyman operation. Driveway gates combine structural work (posts, hinges, welds) with low-voltage electrical work (the motor, the photo-eyes, the keypad). That’s two trades in one box, and most companies only do one of them well. Our technicians have up to 12 years of experience, and every job runs under The Haven Standard: a written price before any work starts and a photo record when we leave. If you’re starting from scratch, our Gate Installation in Whitney page covers the site survey and permit side of a new build.
Key Takeaways
- Driveway gate work in Whitney runs from about $180 for a repair to $7,500 or more for a full automated install.
- A written price is handed to you before anyone picks up a tool, every time.
- We service nine automation brands, including Ghost Controls, DoorKing, Elite, and Mighty Mule, so we work with the motor already on your property.
- Every visit leaves a photo log of what we found, what we set, and what we replaced.
When You Need Driveway Gate
Homeowners call us for a handful of reasons that come up again and again in this part of the Las Vegas valley. Here’s what we actually see on the driveway.
- The gate opens halfway and stops. Usually a limit switch set past its travel point or a motor that’s been fighting a warped panel for months. We read the switch position, photograph it, and reset it. If the arm is worn, we tell you before replacing anything.
- One side sags and drags on the ground. A hinge or post has shifted. Whitney’s soil moves with the summer heat and the occasional winter freeze, and a gate hung on a post that’s gone a quarter-inch out of plumb will drag within a season.
- The photo-eye is tripped and won’t clear. A photo-eye (the infrared beam that stops the gate if something crosses the path) gets knocked out of alignment by a trash can, a dog, or a car bumper. It’s a fast fix when you know where to look.
- The keypad or remote stopped working after a power event. Brownouts are common in older valley neighborhoods. Sometimes it’s the receiver, sometimes it’s a control board that needs a reset and a documented re-program.
- The old gate is loud, slow, and you want to stop getting out of the car in the rain. That’s an automation upgrade, not a replacement, and we’ll tell you honestly which one your existing gate needs.
- You’re putting in a gate for the first time. New driveway gates need the right post depth, the right operator, and access control that matches how your household actually comes and goes.
Our Driveway Gate Process

Every driveway gate job follows the same sequence. It keeps the price honest and keeps the next technician from having to guess.
- Phone intake with a live person. You describe what the gate does and what you want it to do. We ask about the operator brand, the gate material, and whether there’s any access control already wired. No voicemail loop, any hour.
- On-site assessment and written scope. We test the operator, check the hinges and posts, read the limit switches, and test the safety devices. Then we hand you a written price with the parts and labor broken out. No work starts until you have that paper.
- Work performed. Repairs, adjustments, motor replacement, or new install. Our technicians are background-checked and uniformed, and you get their name and photo before they arrive.
- Documentation before we leave. Under Clause 4 (Evidence on every job), you get a photo log of every adjustment, a written record of the part number installed, and the readings we took. It goes home with you and stays in the job file.
- 365-Day Done Right Promise. If the repair isn’t right within a year, we make it right. No argument, no fee, no expiration inside that window.
Before
AfterDriveway Gate Pricing in Whitney
Here’s what driveway gate work costs in Whitney. These are typical ranges, written in dollars, not a “call for a quote.” The flat price you get on site is the price you pay.
| Job | Typical Range | What drives the number |
|---|---|---|
| Photo-eye realignment or replacement | $180 – $340 | Access to the wiring, whether the bracket is bent |
| Limit switch reset or replacement | $160 – $300 | Operator brand, control board access |
| Hinge repair or replacement (per hinge) | $140 – $320 | Weld vs. bolt-on, gate weight |
| Post reset or re-plumb | $350 – $900 | Concrete, post depth, gate size |
| Swing-gate motor replacement | $650 – $1,400 | Brand, whether the arm bracket is intact |
| Sliding-gate operator replacement | $800 – $1,800 | Track condition, rack length, operator model |
| Keypad or receiver install/program | $220 – $480 | Wiring run, brand pairing |
| Full new automated driveway gate | $3,800 – $7,500+ | Span, material, operator, access control |
What moves a price up or down: the span of the gate, the material (steel, aluminum, or wrought iron), whether the posts are new or existing, and how much access control you want. A single household with one remote and one keypad is a different job than a shared driveway with call boxes and a DoorKing entry system. We work with nine major automation brands, including Ghost Controls, Elite, and Mighty Mule, so we’re not going to steer you toward a replacement when a repair to the motor you already own is the better call.
If you’ve got a written estimate from another company, bring it. We’ll review it at no cost and tell you what we’d charge and why – that’s our free second opinion, and it’s part of the same promise to have it in writing. Bring the paperwork and we’ll read it line by line.
How Long Does a Driveway Gate Install Take in Whitney?

A new automated driveway gate usually takes one to three days from start to finish, depending on the span, the material, and whether new posts need to be set and cured. A motor replacement is typically a half day. A repair like a photo-eye or limit switch is often under an hour.
New post footings need concrete to cure before the gate goes on, so a wide swing gate on fresh posts will add a day to the schedule versus a gate hung on existing posts. We’ll tell you the timeline in writing along with the price, so you’re not guessing about access to your driveway on a given morning.
Repair or Replace a Driveway Gate Motor?
Repair the motor if it’s a reputation brand, the control board is sound, and the failure is a discrete part. Replace it if the motor has been through multiple failures, if the housing is corroded through, or if the part is no longer made.
Most operators we see on Whitney driveways fail on a five to twelve year curve. If your motor is inside that window and the failure is a photo-eye, a limit switch, or a receiver, a repair at $180 to $340 is almost always the smarter spend. If you’re looking at a motor on its second or third failure and the parts are discontinued, that’s when replacement makes sense, and we’ll show you the reason in writing before you decide. We service Ghost Controls, DoorKing, Elite, Mighty Mule, LiftMaster, FAAC, BFT, Linear, and Viking, so we’re not locked into any one brand.
FAQs – Driveway Gate

How much does a driveway gate cost in Whitney?
A new automated driveway gate in Whitney runs roughly $3,800 to $7,500 depending on span, material, operator, and access control. Repairs start around $160 for a limit switch reset and climb to about $1,800 for a sliding-gate operator replacement. Call (844) 797-4861 for an exact written quote – estimates are free and you get the price before any work starts.
Can you come out today?
Often, yes. A live person answers the phone at (844) 797-4861 at any hour, and we book same-day and next-day driveways where the schedule allows. Tell us what the gate is doing and we’ll give you an honest window on the call.
Do you work on the motor I already have?
In most cases, yes. We service nine major gate-automation brands, including Ghost Controls, DoorKing, Elite, and Mighty Mule, so a repair to the operator you already own usually beats a replacement. If the part is discontinued or the board has failed twice, we’ll tell you in writing why replacement is the better call.
What do I get in writing after the job?
A photo log of what we found and what we adjusted, the part number installed, and the readings we took on the limit switches. It’s left with you and filed in the job record. If anything isn’t right within 365 days, we make it right under the Done Right Promise, at no additional charge.
Is It Cheaper to Repair or Replace a Driveway Gate?
Repair is cheaper in almost every case where the structure of the gate and the operator board are sound. A hinge, photo-eye, or limit-switch repair at $160 to $340 beats a new gate every time. Replacement makes sense when the posts have failed, the operator is discontinued, or the gate panel is so warped that no adjustment holds. We’ll show you which one you’re looking at before we quote.
One thing we won’t do is pad a repair with parts you don’t need. If you’ve had a written estimate from another company, bring it in and we’ll review it at no charge. That’s part of what we call The Haven Standard, and it’s in your interest to use it.
Safety Notes on Driveway Gates

A driveway gate is a heavy moving object, and the safety devices that stop it are the difference between a working gate and a hazard. We test photo-eyes, reverse loops, and force limits on every visit, and if a safety device is missing or bypassed, we flag it in writing before we leave. A gate that closes without a working photo-eye is a real risk, especially where kids or pets use the driveway. Call us if yours isn’t stopping when something crosses the path.
If your driveway gate needs a repair, a motor, a new install, or just a documented check before you trust it, call Vance Gate Repair Whitney at (844) 797-4861 for a free estimate. A live person answers at any hour, the price comes to you in writing before work starts, and you’ll have a photo record when we leave. Start with a call, and we’ll go from there.
If you’re weighing a new build against a repair, our home page and our Gate Installation service page lay out the difference between the two.
Written by the team at Vance Gate Repair Whitney, serving Whitney.